Maytag / Whirlpool Washer F6 E2 & F6 E3 Error: Control Board Fix
Quick Answer: The F6 E2 or F6 E3 error code on a Maytag or Whirlpool washer indicates a communication failure between the User Interface (UI) display console and the Main Appliance Control Unit (ACU) board (#W11322886 / #W10816419).
⚠️ Check the Ribbon Connector Corrosion First! Before replacing the control board for F6 E2, unplug the washer and open the top console: steam from hot washes often oxidizes the 3-wire communication plug connecting the display to the lower board.
#1 Most Common Fix: Maytag / Whirlpool Electronic Control Board
Official OEM Part Number: #W11116590
⏱️ Install Time: 20 Minutes | 💰 Avg Cost: $125.00 – $179.00
Step 1: Free 2-Minute Reset & Test
- Unplug the washing machine from the wall outlet for a full 10 minutes to reset both microprocessors.
- Remove the rear upper console screws, unplug the J2 communication wire harness between the top UI panel and main board, spray electrical contact cleaner on the pins, and reconnect firmly.
- If F6 E2 or F6 E3 returns, replace the shorted Control Board or Lid Lock harness.
Step 2: Symptom & Part Number Lookup Table
| Symptom | Required OEM Part | Difficulty & Cost | Action |
|---|---|---|---|
| Display flashes F6 E2 or F6 E3, buttons become unresponsive, or washer stops mid-cycle Cause: Failed communication transceiver on Main Control Board | Whirlpool / Maytag Main Control Board (ACU)#W11116590 | Easy DIY (20 min) Est: $148.00 | Check Price on Amazon → |
Frequently Asked Questions
Can a bad lid lock or drain pump trigger F6 E3 on a Maytag washer?
Yes! On certain Maytag Bravos models, if a frayed wire on the lid lock (#W11307244) shorts the 5V DC bus line to ground, it pulls down communication on the main board and displays F6 E3.