LG Washer IE Error Code: Water Inlet Fix & Valve Part (#5220FR2075L)
Quick Answer: The IE (Inlet Error) code on an LG washing machine means the tub did not fill to the preset water level within 8 minutes. It is caused by sediment clogging the inlet valve filter screens or a failed Cold Water Inlet Valve (#5220FR2075L).
⚠️ 1E vs IE Confusion: Many users read this code as '1E' (number one + E), but it is actually 'IE' (Inlet Error). If both faucets are open and the hose screens are clean, the solenoid coil on valve #5220FR2075L has burned out.
#1 Most Common Fix: LG Cold Water Inlet Valve Assembly
Official OEM Part Number: #5220FR2075L
⏱️ Install Time: 10 Minutes (2 screws under top cover) | 💰 Avg Cost: $16.99 – $24.00 (Saves $300 service call)
Step 1: Free 2-Minute Reset & Test (Try This First)
Before ordering replacement parts, perform this quick reset sequence to rule out a temporary sensor trip:
- Turn off both hot and cold water supply faucets behind the LG washer.
- Unscrew the water hoses from the back of the machine and inspect the tiny mesh screens inside the valve ports.
- Clean any rust or calcium build-up from the screens with vinegar and a brush.
- Reattach the hoses, turn the faucets fully on, and run a normal cycle.
Step 2: 60-Second Symptom & Part Number Lookup Table
Match your exact LG IE symptom below to get the factory replacement part number:
| What You Are Seeing (Symptom) | Required OEM Part & Number | Difficulty & Cost | Direct Part Link |
|---|---|---|---|
| IE code appears at the very start of the wash cycle or during the cold rinse Cause: Failed Cold Water Solenoid Valve |
LG Cold Water Inlet Valve (12V)#5220FR2075L |
Very Easy DIY (10 min) Est: $18.50 |
Check Price on Amazon → |
| IE code only appears when washing with Warm or Hot water settings Cause: Failed Hot Water Solenoid Valve |
LG Hot Water Inlet Valve#5220FR2006H |
Very Easy DIY (10 min) Est: $19.99 |
Check Price on Amazon → |
Frequently Asked Questions (LG IE)
How long does it take to replace LG water inlet valve #5220FR2075L?
Only 10 minutes. Unplug the washer, remove the two screws holding the back of the top lid, slide the lid back, unplug the wire harness from the valve, remove two mounting screws on the back panel, and swap the new valve in.