Bosch Dishwasher E25 Error: Blocked Pump Fix & Cover Part (#00611322)
Quick Answer: The E25 error code on a Bosch dishwasher means the drain pump impeller is physically jammed by foreign debris (such as broken glass, a pistachio shell, or dental floss) OR the white plastic pump cover (#00611322) inside the sump is loose. If the impeller is clear, the Drain Pump (#00631200) bearings have seized.
⚠️ E24 vs E25 Difference: E24 means the drain hose is restricted further down the line, whereas E25 specifically means the motor impeller right at the bottom of the dishwasher cannot spin! Always check under the white spoon-shaped cover (#00611322) first.
#1 Most Common Fix: Bosch OEM Drain Pump & Impeller Cover
Official OEM Part Number: #00631200
⏱️ Install Time: 10 Minutes | 💰 Avg Cost: $34.00 – $39.00 (Saves $300 service call)
Step 1: Free 2-Minute Reset & Test (Try This First)
Before ordering replacement parts, perform this quick reset sequence to rule out a temporary sensor trip:
- Turn off the dishwasher, remove the bottom rack, and twist out the cylindrical mesh filter.
- Sponge out the standing water in the sump pit and pry up the small white plastic pump cover on the left side of the pit (wear gloves in case of broken glass).
- Use tweezers to pull out any glass shards, fruit pits, or string wrapped behind the impeller blades until the little fan wheel turns smoothly with your finger.
- Snap the white cover back down until it CLICKS loudly—a loose cover will immediately cause E25 again!
Step 2: 60-Second Symptom & Part Number Lookup Table
Match your exact Bosch E25 symptom below to get the factory replacement part number:
| What You Are Seeing (Symptom) | Required OEM Part & Number | Difficulty & Cost | Direct Part Link |
|---|---|---|---|
| White plastic locking tab on the pump cover is worn out and won't click tightly Cause: Loose impeller cover causing cavitation and E25 |
Bosch Drain Pump Cover Piece#00611322 |
10-Second Snap-In Est: $8.99 |
Check Price on Amazon → |
| Impeller pit is 100% clean and cover is clicked in, but pump still stalls with E25 Cause: Worn out internal rotor bearings inside Drain Pump |
Bosch OEM Drain Pump Motor#00631200 |
Easy DIY (15 min) Est: $36.99 |
Check Price on Amazon → |
Frequently Asked Questions (Bosch E25)
Can a missing pump cover cause error E25 on a Bosch dishwasher?
Yes! Without the white plastic cover (#00611322) snapped tightly over the blades, the pump cannot build suction pressure and the control board interprets the lack of water resistance as a pump fault (E24/E25).