Beko / Blomberg Dishwasher E01 & E02 Error: Flood & Inlet Fix (#1760900100)
Quick Answer: On a Beko or Blomberg dishwasher, E01 indicates water has leaked into the bottom overflow tray (lifting the float switch), while E02 means no water is entering the machine due to a faulty Water Inlet Valve (#1887460200) or Flow Meter Turbine (#1760900100).
⚠️ Beko E02 Plastic Impeller Wheel: Inside the left side wall of every Beko dishwasher is a small plastic paddlewheel called the Flow Meter (#1760900100). When limescale stops that tiny wheel from spinning, the dishwasher fills with water, thinks no water entered, and flashes E02!
#1 Most Common Fix: Beko / Blomberg Water Flow Meter Turbine Sensor
Official OEM Part Number: #1760900100
⏱️ Install Time: 15 Minutes | 💰 Avg Cost: $15.99 – $24.00
Step 1: Free 2-Minute Reset & Test
- For E01 (Overflow Leak): Unplug the dishwasher, tilt it 45 degrees forward onto a towel to drain the base tray, and inspect the lower sump hoses for drips.
- For E02 (Water Supply Fault): Check that the sink water tap is open. If water enters the tub for 30 seconds and then drains out with E02, replace the Flow Meter (#1760900100).
Step 2: Symptom & Part Number Lookup Table
| Symptom | Required OEM Part | Difficulty & Cost | Action |
|---|---|---|---|
| Water enters the Beko dishwasher briefly, then drains out and displays E02 Cause: Failed reed switch on Water Flow Meter Turbine | Beko OEM Flow Meter Impeller Sensor#1760900100 | Easy DIY (15 min) Est: $18.50 | Check Price on Amazon → |
| Dishwasher stays completely dry inside when starting a cycle and flashes E02 Cause: Burned out Water Inlet Solenoid Valve | Beko Dishwasher Water Inlet Valve#1887460200 | Easy DIY (15 min) Est: $22.99 | Check Price on Amazon → |
Frequently Asked Questions
Why does my Beko dishwasher pump keep running with the door open (E01)?
Code E01 activates the anti-flood float switch in the base pan, locking the drain pump ON to prevent kitchen flooding. Drying the bottom tray stops the pump immediately.